Posted by Haknhendrix [ 68.116.166.42 ] on February 28, 2004 at 19:48:06:

After receiving the Pi crossover schematics from Wayne, and following a bunch of threads on the subject in the forum, I think I am almost there.

In consideration of using the PXB2-1K6 Eminence crossover for the 4 PI theater (Delta 15a, PSD2002), I would like to confirm and get suggestion on the following:

Tweeter Compenstion: R1, R2, and C1.

R1 and R2 would be constructed from two sets of four 30 ohm, 10 Watt resistors. This would provide a create a 16 ohm, 40 watt network. Would use PE part number: 004-30.

C1 - not much luck in tracking down a 0.47 uF, 200V (NP) capacitor - any suggestions?

Woofer Zobel configuration: C5 and R3.

R3 - requires an 8ohm resistor. Please advise as to what dummy load resistor would be appropriate, the 100 watt or the 200 watt version (019-020 or 019-030 respectively).

C5 - 20 uF - what voltage rating would be advised and what PE partnumber would be appropriate?

By the way, I will be using a 100W SS amp for the time being - does this impact the crossover componentry?

Thanks in advance!
Hakn

Replies:

• Re: CrossOver questions on 4 Pi - Wayne Parham 02:28:12 02/29/04 (5)
  • Re: CrossOver questions on 4 Pi - GarMan 15:38:10 03/03/04 (3)
    • Re: CrossOver questions on 4 Pi - Wayne Parham 20:47:12 03/03/04 (2)
      • Crossover Wire Recommendation - Haknhendrix 10:23:59 03/05/04 (1)
        • Re: Crossover Wire Recommendation - Wayne Parham 19:09:49 03/05/04 (0)
  • Re: CrossOver questions on 4 Pi - Haknhendrix 11:03:20 03/03/04 (0)