Posted by colinhester [ 65.186.5.10 ] on March 04, 2005 at 09:03:41:

In Reply to: Filament Caps posted by manualblock on March 04, 2005 at 07:47:19:

I used what was on the heater schematic, which was 4.7 mF (4700uF)and I believe 25V rating. See link below and remember the resistors were changed to 2 and 2 ohm......Colin

• http://audioroundtable.com/GroupBuild/messages/397.html

Replies:

• Re: That's what I used - manualblock 09:22:44 03/04/05 (8)
  • That's what I used - Tnuctipun 09:29:28 03/04/05 (7)
    • Is cap size worth increasing in heater PS? - colinhester 14:18:03 03/04/05 (2)
      • Re: Is cap size worth increasing in heater PS? - manualblock 14:35:49 03/04/05 (1)
        • Up and running w/ about 15 hours on the pre - colinhester 14:43:21 03/04/05 (0)
    • Less ripple w/10k uF - colinhester 09:47:20 03/04/05 (3)
      • Re: Less ripple w/10k uF - manualblock 10:06:36 03/04/05 (2)
        • Re: Less ripple w/10k uF - Tnuctipun 11:21:12 03/04/05 (1)
          • Re: Less ripple w/10k uF - manualblock 12:15:18 03/04/05 (0)