Posted by colinhester [ 65.186.5.10 ] on February 14, 2005 at 17:56:45:

In Reply to: Capacitors posted by manualblock on February 14, 2005 at 17:13:31:

There's going to be a lot of weight when things are done - that's for sure. I'm using an L-channel under the chassis. This will be placed in under the front mounting holes of botn Tx's and the choke, thus fewer scwers poking through the top (thanks GarMan).

Have you started to lay out the CCS? I ran into a concern last night the way I have things on the PC board. The output to the coupling cap and the power (B+ from MOSFETs) are pretty close together, about 1/2". I'm hopeing I'm not going to run into any problems with noise. I think this is where the shielded cable is really going to come in handy......Colin

Replies:

• Re: Capacitors - manualblock 18:33:25 02/14/05 (11)
  • Re: Capacitors - colinhester 18:44:48 02/14/05 (10)
    • Re: Capacitors - manualblock 07:30:27 02/15/05 (9)
      • Re: Capacitors - Tnuctipun 08:26:40 02/15/05 (8)
        • Re: Capacitors - Wayne Parham 23:40:38 02/15/05 (4)
          • but... - Tnuctipun 06:52:47 02/16/05 (2)
            • "Valve Amplifiers 3" - again :-) - Damir 07:26:36 02/16/05 (1)
              • "Valve Amplifiers 3" - Tnuctipun 07:43:52 02/16/05 (0)
          • two words... - Tnuctipun 06:49:12 02/16/05 (0)
        • Re: Capacitors - manualblock 16:37:21 02/15/05 (2)
          • LED's - Tnuctipun 17:40:59 02/15/05 (1)
            • Re: LED's - Wayne Parham 23:38:49 02/15/05 (0)