Posted by colinhester [ 65.186.5.10 ] on February 12, 2005 at 11:09:00:

I'm starting to put things in place (now I know why they call it stuffing) are there any other tips to on placing components. Earlier it was mentioned that the DM2540s should be at right angles, which I've done. The Tx's and choke arealso set at right angles to one another.

I will be using Belden 8450 (2 conductor shielded w/drain) as much as possible for signal and power path. Heaters will be wired with silver-plated copper wire with Teflon insulation. I will mimick Bottlehead's SEX kit as much as possible for the appropriate wiring choice.

What about grounding the Tx and choke frames to earth? Also, the tube sockets I'm using have a center pen for ground. Should this go to earth as well?

Any and all suggestions are more than welcome......Colin

Replies:

• Re: Guinevere layout tip, Cap mounting - Forty2wo 13:05:31 02/12/05 (1)
  • Re: Guinevere layout tip, Cap mounting - Tnuctipun 15:54:54 02/13/05 (0)
• Re: Guinevere layout tips? - Forty2wo 12:36:21 02/12/05 (2)
  • Re: Guinevere layout tips? - Forty2wo 15:36:01 02/12/05 (1)
    • Re: Guinevere layout tips? - Tnuctipun 22:07:31 02/14/05 (0)