Posted by Tnuctipun [ 172.155.216.162 ] on January 19, 2005 at 12:59:38:

In Reply to: Re: Sourcing parts posted by colinhester on January 19, 2005 at 11:38:10:

There are a few changes. One being the rectifier. The new revision is a standard full wave. HV to the plates, ground the CT and continue as drawn. No SS required to assemble a full bridge. The choke is now changed to the big Heyboer 8039, but the 100 uF/370VAC from eBay's midorimeadows is not changed. probably best to run the 6CA4, though a pair of 6AX4 or 6W4 are also 'do-able' since we have 3A to cover the 2.4A required for using two damper diodes.

Look at Bas Hornman's site on the active loads.

I can't think of anything else of any importance.
regards,
Douglas

• MOSFET CCS page

Replies:

• Dual rectifiers - colinhester 13:48:29 01/19/05 (1)
  • Re: Dual rectifiers - Tnuctipun 15:29:44 01/19/05 (0)
• Wayne, Can you OrCAD this? - colinhester 13:33:08 01/19/05 (1)
  • Re: Wayne, Can you OrCAD this? - Wayne Parham 13:52:02 01/19/05 (0)