Back to square one, so to speak

[ Craftsmen Forum ] [ Help ]

Posted by lon [ 209.103.193.21 ] on August 29, 2004 at 15:42:39:

I noticed I had this huge problem getting my rotozip tool
circle cutter to make a cutout the same size... ever.


The centering pin might be loosening up as I work the device.


Other problem is I am using the smallest diameter the
circlemaker has, so I can't simply set it lower.


The centering pin is this big fat sloppy thing. I'd
be better off to use one odf those $6 attachments for
a jig saw, but again, I'm trying to use the smallest
dimension for 4" drivers in an array project.

I don't know if there's any help for this or not (?)


In any case, the box of 50 cent speaks I got on closeout
does not suggest any new tool purchases right now... not
until Sir Fitz gets his line array published. :-)




Replies:



[ Craftsmen Forum ] [ Help ]