Re: T-nuts, their care and feeding

[ Craftsmen Forum ] [ Help ]

Posted by lon [ 69.28.4.35 ] on January 27, 2007 at 11:53:13:

In Reply to: Re: T-nuts, their care and feeding posted by Bob Brines on January 27, 2007 at 08:16:37:

Yah, I was doing it incorrectly.

The goal was to have a flush flat metal surface to attach a grille
with magnets on it. The surface t-nuts would then be masked
when the grilles were attached.

Only other option I could think of are fender washers. But those
done sit flush either. The hurricane nuts and t-nuts in general
have a dimple which would allow a flathead screw to be flush. At least
that's the way they look.


Replies:



[ Craftsmen Forum ] [ Help ]