AudioRoundTable.com: Pi Speakers » Finishing details for π cornerhorns

Home » Sponsored » Pi Speakers » Finishing details for π cornerhorns

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Finishing details for π cornerhorns [message #46875 is a reply to message #46873]

Thu, 12 May 2005 18:24

BillEpstein
Messages: 886
Registered: May 2009

Illuminati (2nd Degree)

For those of us unable to use a tape measure, ME, these Dowel Centers are required, also from Woodcraft
Ya drill a hole in one part and put the center in it. Then ya lower the othere part into place and sit onit. The pin on the center marks the drilling location. Muy facil!

Dowel Centers

Report message to a moderator

[Message index]

		Finishing details for π cornerhorns By: Wayne Parham on Thu, 12 May 2005 03:03
		Re: Finishing details for π cornerhorns By: BillEpstein on Thu, 12 May 2005 18:24
		Re: Finishing details for π cornerhorns By: Wayne Parham on Fri, 13 May 2005 00:41

Previous Topic:	Wayne, ya did it again!
Next Topic:	Pi 1's

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Apr 20 05:09:20 CDT 2024