In consideration of using the PXB2-1K6 Eminence crossover for the 4 PI theater (Delta 15a, PSD2002), I would like to confirm and get suggestion on the following:

Tweeter Compenstion: R1, R2, and C1.

R1 and R2 would be constructed from two sets of four 30 ohm, 10 Watt resistors. This would provide a create a 16 ohm, 40 watt network. Would use PE part number: 004-30.

C1 - not much luck in tracking down a 0.47 uF, 200V (NP) capacitor - any suggestions?

Woofer Zobel configuration: C5 and R3.

R3 - requires an 8ohm resistor. Please advise as to what dummy load resistor would be appropriate, the 100 watt or the 200 watt version (019-020 or 019-030 respectively).

C5 - 20 uF - what voltage rating would be advised and what PE partnumber would be appropriate?

By the way, I will be using a 100W SS amp for the time being - does this impact the crossover componentry?

Thanks in advance!
Hakn