AudioRoundTable.com: Pi Speakers » How do you guys do your measurements??

Home » Sponsored » Pi Speakers » How do you guys do your measurements??

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

How do you guys do your measurements?? [message #35146]

Sun, 17 February 2002 10:57

Robert Hamel
Messages: 93
Registered: May 2009

Viscount

Hello, I am in the middle of getting my project together and was wondering what types of measurements and how you do them?? I have an SPL meter and a crude 10 octate RTA set-up. So I can do them nearfield but how do you guys do the system measurements say 6-8 feet out so its all blended while minimizing the rooms contributions?? I have one cabinet built and I am attempting the crossovers now. The obvious thing would be to measure outside but that is just not practical. I am in NY and its too damn cold and the speakers are way to heavy to get up and down stairs. Any ideas would be appreciated.

Thanks Rob

Report message to a moderator

[Message index]

		How do you guys do your measurements?? By: Robert Hamel on Sun, 17 February 2002 10:57
		Measuring loudspeaker performance By: Wayne Parham on Sun, 17 February 2002 18:45
		measure where the rubber meets the road By: Sam P. on Mon, 18 February 2002 03:59
		Re: measure where the rubber meets the road By: Robert Hamel on Mon, 18 February 2002 19:15
		Thanks I will check it out! nt By: Robert Hamel on Mon, 18 February 2002 19:00

Previous Topic:	another horn hater www.audioperfectionist.com
Next Topic:	800hz ksn1188 fourPi alpha crossover an horn

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 14 09:24:16 CDT 2024