AudioRoundTable.com: Group Build

Home » Audio » Group Build » Butt-joint veneer

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Butt-joint veneer [message #32164 is a reply to message #32163]

Tue, 10 April 2007 21:22

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

Not really sure what type of venner I'll be using. I bought a pile of various lots from our local Rockler. The veneer is not paper backed, and I'll be using glue to bond the MDF substrate. I'm really concerned about getting a nice joint, so that rules out anything but the flattest (non-wavey) veneer.

I assume the best way is to make sure the pieces I'm butting have a perfectly straight edge and then roll the seam with a wooden roller.

Any hints you can offer will be appreciated.....Colin

Report message to a moderator

[Message index]

		Butt-joint veneer By: colinhester on Sat, 07 April 2007 14:18
		Re: Butt-joint veneer By: Seeker on Tue, 10 April 2007 12:41
		Re: Butt-joint veneer By: colinhester on Tue, 10 April 2007 21:22
		Re: Butt-joint veneer By: Seeker on Wed, 11 April 2007 09:20
		Re: Butt-joint veneer By: colinhester on Wed, 11 April 2007 13:02
		Re: Hey Colin, get out that fancy router and table saw By: Bill Epstein on Thu, 26 April 2007 20:09

Previous Topic:	The ausio Asylum is done
Next Topic:	ART arrays near Iowa, Nebraska???

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon May 13 14:32:38 CDT 2024