AudioRoundTable.com: Group Build » Resistor choices for SV811 project

Home » Audio » Group Build » Resistor choices for SV811 project

Wed, 07 December 2005 11:09

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

So, a single 5W 470k ohm resistor parallel with the 40uF cap should suffice to both bleed the caps (10, 50 and 40uF). Correct?....Thanks again, Colin

		Resistor choices for SV811 project By: colinhester on Tue, 06 December 2005 08:16
		Re: Resistor choices for SV811 project By: Damir on Tue, 06 December 2005 12:16
		Re: Resistor choices for SV811 project By: Norris Wilson on Tue, 06 December 2005 15:05
		Thanks By: colinhester on Wed, 07 December 2005 10:58
		Re: Resistor choices for SV811 project By: PakProtector on Tue, 06 December 2005 15:59
		Re: Resistor choices for SV811 project By: 2wo on Tue, 06 December 2005 16:21
		Re: Resistor choices for SV811 project By: Damir on Wed, 07 December 2005 06:21
		Warning, Will Robinson By: colinhester on Wed, 07 December 2005 11:01
		Damir is right as usual By: 2wo on Wed, 07 December 2005 22:06
		Bleeders By: colinhester on Wed, 07 December 2005 11:09

Previous Topic:	The shunt capacitance of grid and anode chokes
Next Topic:	C-Core grid chokes

Goto Forum:

] [

]

Current Time: Fri May 10 23:15:22 CDT 2024