Home » Audio » Group Build » DC filament supply
DC filament supply [message #31140] Sat, 04 June 2005 10:54
Damir is currently offline  Damir
Messages: 1005
Registered: May 2009
Illuminati (2nd Degree)
For (DRD) 300B amp below - say we have only 6,3V winding (or 6,6V without load, Rw=0,1 Ohm), and need 5V/1,2A "super clean" DC.
Schottky bridge, then what? Many people "complain" that usual solutions - "low drop" 3-leg regulators, serial transistor reg., RCRC or even CLC (large electrolitic needed) are not good enough for DHT filament=cathode.
Any ideas?

Report message to a moderator

[Message index]
 
Read Message
Previous Topic: "Hybrid bridge rectifier" article - little OT
Next Topic: 45 power trans/6072A driver tube
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Sep 04 08:19:43 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest