AudioRoundTable.com: Group Build » Location of Selector Switch in Preamp

Home » Audio » Group Build » Location of Selector Switch in Preamp

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Location of Selector Switch in Preamp [message #30875]

Mon, 07 March 2005 14:22

GarMan
Messages: 960
Registered: May 2009

Illuminati (2nd Degree)

This question is unrelated to Guinevere, but is about DIY preamps. I've seen a lot of preamps that place the selector switch in the back of the chassis. What benefit would this have? Whether selection happens at the rear or at the front, the signal still has to travel from back to front to the volume knob. I can see that it cleans up wiring a bit, in that only one set of wires has to travel back to front, instead of 2, 3, or 4 sets.

Gar.

Report message to a moderator

[Message index]

		Location of Selector Switch in Preamp By: GarMan on Mon, 07 March 2005 14:22
		Re: Location of Selector Switch in Preamp By: PakProtector on Mon, 07 March 2005 16:06

Previous Topic:	the Amp
Next Topic:	Guinevere wired and ready.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 12:14:18 CST 2024