AudioRoundTable.com: Group Build » LEDs light - can I assume CCS is wires properly?

Home » Audio » Group Build » LEDs light - can I assume CCS is wires properly?

Mon, 28 February 2005 21:26

cheetah
Messages: 70
Registered: May 2009

Viscount

Why can't you put a 1 ohm resistor between R3 and the plate? Then measuring across this resistor, 15mV=15mA.

Impact on circuti should be nil.

Joe

		LEDs light - can I assume CCS is wires properly? By: colinhester on Mon, 28 February 2005 19:13
		Almost certainly By: PakProtector on Mon, 28 February 2005 19:44
		Dead on 130V and stupid question By: colinhester on Mon, 28 February 2005 20:07
		ummmmm By: PakProtector on Mon, 28 February 2005 20:13
		Yeap, blown fuse By: colinhester on Mon, 28 February 2005 20:32
		Re: Yeap, blown fuse By: cheetah on Mon, 28 February 2005 21:26
		Re: Yeap, blown fuse By: PakProtector on Tue, 01 March 2005 05:16

Previous Topic:	Guinever done
Next Topic:	Guinever underside

Goto Forum:

] [

]

Current Time: Thu May 16 09:19:52 CDT 2024