AudioRoundTable.com: Group Build » Guinevere layout tips?

Home » Audio » Group Build » Guinevere layout tips?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Guinevere layout tip, Cap mounting [message #30489 is a reply to message #30487]

Sat, 12 February 2005 12:05

Forty2wo
Messages: 163
Registered: May 2009

Master

A good way to mount that big honking 100mf oil cap.
Cut a hole in your top plate that the body will pass thru but not the lip, clean well. slide your cap in from the bottom and run a bead of GE silicone RTV around the lip. Smaller caps and parts, just glue to the chassie. I don't mean bathtub calk, this is the stuff they use to glue aquarium's together befor filling with hunderds of gallons of water.
This stuff is great. It rivels epoxy in it's bond yet is flexable enough that parts don't crack off from vibration or flexing. It is resistant to the heat found around tubes. is a very good insinulater and if you change your mind you can rescue your part with a sharp knife...John

Report message to a moderator

[Message index]

		Guinevere layout tips? By: colinhester on Sat, 12 February 2005 10:09
		Re: Guinevere layout tips? By: Forty2wo on Sat, 12 February 2005 11:36
		Re: Guinevere layout tips? By: Forty2wo on Sat, 12 February 2005 14:36
		Re: Guinevere layout tips? By: PakProtector on Mon, 14 February 2005 21:07
		Re: Guinevere layout tip, Cap mounting By: Forty2wo on Sat, 12 February 2005 12:05
		Re: Guinevere layout tip, Cap mounting By: PakProtector on Sun, 13 February 2005 14:54

Previous Topic:	Ground scheme
Next Topic:	Guinevere Schematic links

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 14 07:03:31 CDT 2024