AudioRoundTable.com: Group Build » Guinevere layout tips?

Home » Audio » Group Build » Guinevere layout tips?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Guinevere layout tips? [message #30488 is a reply to message #30487]

Sat, 12 February 2005 11:36

Forty2wo
Messages: 163
Registered: May 2009

Master

So far so good. keep the AC and iron away from the low level as much as you can. You are using a copper top plate right? So to start scrap the paint from one mounting lug of the power xformer so that it eather makes good contact with the top of the plate or to a bolt head to the under side. This will be the ac ground. Tie the AC ground (3rd wire) to a lug at this point. ground the choke to the top plate the same way, just to the plate, no lug
I will start a seprate message on gruonds and low level layout after lunch...John

Report message to a moderator

[Message index]

		Guinevere layout tips? By: colinhester on Sat, 12 February 2005 10:09
		Re: Guinevere layout tips? By: Forty2wo on Sat, 12 February 2005 11:36
		Re: Guinevere layout tips? By: Forty2wo on Sat, 12 February 2005 14:36
		Re: Guinevere layout tips? By: PakProtector on Mon, 14 February 2005 21:07
		Re: Guinevere layout tip, Cap mounting By: Forty2wo on Sat, 12 February 2005 12:05
		Re: Guinevere layout tip, Cap mounting By: PakProtector on Sun, 13 February 2005 14:54

Previous Topic:	Ground scheme
Next Topic:	Guinevere Schematic links

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon May 13 17:51:14 CDT 2024