AudioRoundTable.com: Group Build » Schematic

Home » Audio » Group Build » Schematic - first version

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Schematic - first version [message #30149 is a reply to message #30146]

Thu, 20 January 2005 10:36

paba
Messages: 21
Registered: May 2009

Chancellor

Just wandering would the sound be better if you avoid the signal going thru the pot as shown in the schematic. Instead with a series shunt to ground config I think the signal goes thru a good quality resistor instead.

see:
www.lara.on.ca/~gandalf/

www.siteswithstyle.com/voltsecond/12_posistion_shunt/12_Position_Pure_Shunt.html

www.audiosold.com/passivepre.htm

cheers
Paul

Report message to a moderator

[Message index]

		Schematic - first version By: Damir on Thu, 20 January 2005 06:18
		Schematic - second version By: Damir on Thu, 20 January 2005 06:24
		Re: Schematic - second version By: Manualblock on Thu, 20 January 2005 07:02
		Re: Schematic - second version By: Damir on Thu, 20 January 2005 13:40
		PS Schematic -Version ? By: colinhester on Thu, 20 January 2005 15:24
		Re: PS Schematic -Version ? By: Manualblock on Thu, 20 January 2005 17:01
		Re: PS Schematic -Version ? By: PakProtector on Thu, 20 January 2005 17:49
		6X4 rectifier? By: colinhester on Thu, 20 January 2005 18:14
		Re: 6X4 rectifier? By: PakProtector on Thu, 20 January 2005 18:34
		Thank you By: colinhester on Thu, 20 January 2005 11:48
		No problem :-) By: Damir on Thu, 20 January 2005 13:31
		Re: Schematic - first version By: paba on Thu, 20 January 2005 10:36
		Re: Schematic - first version By: Damir on Thu, 20 January 2005 11:26
		Re: Schematic - OrCad file By: Wayne Parham on Thu, 20 January 2005 21:57
		Re: Schematic - OrCad file By: Damir on Fri, 21 January 2005 06:41

Previous Topic:	Potentiometer
Next Topic:	trans order courtesy call

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon May 13 10:17:37 CDT 2024