AudioRoundTable.com: Craftsmen » any stocks of Live Oak up north?

Home » Audio » Craftsmen » any stocks of Live Oak up north?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: I hate Ipe. [message #29939 is a reply to message #29933]

Mon, 29 October 2007 07:59

Skip Pack
Messages: 51
Registered: May 2009
Location: Hollister, California

Baron

Funny you should mention Ipe. I finished the switchbox I had
mentioned in the group build forum a while back -- just cleaning
up the exterior before doing the writeup (over-dignified term
for such a simple device) to post. It's in an AL box and
very light, so I have been fixing up a little plank of ipe
to give it some heft. Chamfered the edges very well with a
router.

Skip

Report message to a moderator

[Message index]

		any stocks of Live Oak up north? By: PakProtector on Sat, 27 October 2007 19:39
		Re: any stocks of Live Oak up north? By: Wayne Parham on Sun, 28 October 2007 09:11
		Re: any stocks of Live Oak up north? By: PakProtector on Sun, 28 October 2007 10:08
		What about Brazilian epay? By: colinhester on Sun, 28 October 2007 12:23
		Re: What about Brazilian epay? By: PakProtector on Sun, 28 October 2007 13:55
		Nothing else will do unfortunately. By: Poindexter on Sat, 22 December 2007 17:40
		I hate Ipe. By: Shane on Sun, 28 October 2007 14:13
		Re: I hate Ipe. By: PakProtector on Sun, 28 October 2007 15:42
		What are you talking about? By: colinhester on Sun, 28 October 2007 16:16
		ranting and raving By: PakProtector on Sun, 28 October 2007 17:21
		Re: I hate Ipe. By: Skip Pack on Mon, 29 October 2007 07:59
		Re: any stocks of Live Oak up north? By: Wayne Parham on Sun, 28 October 2007 14:29
		heh-heh-heh!!! By: PakProtector on Sun, 28 October 2007 15:39
		Re: heh-heh-heh!!! By: Bill Epstein on Wed, 31 October 2007 07:45
		Re: heh-heh-heh!!! By: PakProtector on Thu, 01 November 2007 13:27
		Re: any stocks of Live Oak up north? By: McKinneyMike on Sat, 01 August 2009 17:28

Previous Topic:	Non Metalic Chassis
Next Topic:	Finishing Padauk is a pleasure

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 16 02:00:44 CDT 2024