AudioRoundTable.com: Craftsmen

Home » Audio » Craftsmen » Trimming veneer

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Trimming veneer [message #29912]

Tue, 11 September 2007 08:29

colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas

Illuminati (3rd Degree)

About to do a large box in teak veneer. In the past I've laid the veneered box face down on MDF and trimmed with a very sharp knife. Seems to work well, but very time consuming.

I've also used an edge band trimmer, but always get tear-out going in and coming out, even with a new blade. Also, I've used a laminate trimmer bit designed for the roto-zip - the bit looks like a cylinder with a square notch. Again, not much luck as it tended to score the edge beyond repair.

Any ideas?......C

Report message to a moderator

[Message index]

		Trimming veneer By: colinhester on Tue, 11 September 2007 08:29
		Re: Trimming veneer By: Bob Brines on Tue, 11 September 2007 16:56
		Re: Trimming veneer By: colinhester on Wed, 19 September 2007 20:09
		Re: Downshear flush trim bit By: Bill Epstein on Sun, 23 September 2007 11:53
		Re: Downshear flush trim bit By: DaBase on Wed, 24 February 2010 22:03

Previous Topic:	Nitrocellulose
Next Topic:	Need to find a cabinet refinisher

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 02:21:17 CST 2024