AudioRoundTable.com: Craftsmen » T-nuts, their care and feeding

Home » Audio » Craftsmen » T-nuts, their care and feeding

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: T-nuts, their care and feeding [message #29883 is a reply to message #29882]

Mon, 12 February 2007 12:58

Bob Brines
Messages: 186
Registered: May 2009
Location: Hot Springs Village, AR

Master

I find that the best way to seat t-nuts is to get a hex head bolt of the right size, place a washer on the outside of the panel and thread the bolt through the t-nut. now tighten down the bolt with a socket wrench or an end wrench until the t-nut is seated. This also guarantees the the t-nut will be square with the hole.

Bob

Report message to a moderator

[Message index]

		T-nuts, their care and feeding By: lon on Thu, 25 January 2007 12:40
		Re: T-nuts, their care and feeding By: Bob Brines on Fri, 26 January 2007 07:40
		Re: T-nuts, their care and feeding By: lon on Fri, 26 January 2007 13:36
		Re: T-nuts, their care and feeding By: Bob Brines on Sat, 27 January 2007 07:16
		Re: T-nuts, their care and feeding By: lon on Sat, 27 January 2007 10:53
		Re: T-nuts, their care and feeding By: gfederys on Fri, 02 February 2007 07:53
		Re: T-nuts, their care and feeding By: lon on Sat, 10 February 2007 16:05
		Re: T-nuts, their care and feeding By: Bob Brines on Sun, 11 February 2007 10:23
		Re: T-nuts, their care and feeding By: lon on Sun, 11 February 2007 11:41
		Re: T-nuts, their care and feeding By: Bob Brines on Mon, 12 February 2007 12:58
		Re: T-nuts, their care and feeding By: Jeffery L on Fri, 28 December 2007 07:08
		Re: T-nuts, their care and feeding By: badman on Thu, 03 June 2010 16:22
		Re: T-nuts, their care and feeding By: Wayne Parham on Thu, 03 June 2010 19:27
		Re: T-nuts, their care and feeding By: badman on Thu, 03 June 2010 23:11
		Re: T-nuts, their care and feeding By: badman on Fri, 04 June 2010 09:40
		Re: Just to muddy the waters.... By: Bill Epstein on Mon, 29 January 2007 03:32
		Re: Just to muddy the waters.... By: Bob Brines on Mon, 29 January 2007 10:39
		Re: Good point By: Bill Epstein on Mon, 29 January 2007 12:01

Previous Topic:	Need to find a cabinet refinisher
Next Topic:	Nostalgic DIYers

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon May 13 11:02:53 CDT 2024