AudioRoundTable.com: Craftsmen » T-nuts, their care and feeding

Home » Audio » Craftsmen » T-nuts, their care and feeding

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: T-nuts, their care and feeding [message #29871 is a reply to message #29870]

Sat, 27 January 2007 07:16

Bob Brines
Messages: 186
Registered: May 2009
Location: Hot Springs Village, AR

Master

I don't think I understood exactly how you were using the t-nuts (hurricane nuts).Are you putting one t-nut on the back of the furring strip AND one t-nut on the back of the panel? If so -- no, no no! Just one t-nut per mounting hole, on the back of the furring strip. Assuming a 1/4" bolt, you drill a 1/4" clearance hole through the panel and a 5/16" hole through the furring strip. Drop the bolt thought the panel and thread it into the single t-nut. The panel will tighten down nicely.

Bob

Report message to a moderator

[Message index]

		T-nuts, their care and feeding By: lon on Thu, 25 January 2007 12:40
		Re: T-nuts, their care and feeding By: Bob Brines on Fri, 26 January 2007 07:40
		Re: T-nuts, their care and feeding By: lon on Fri, 26 January 2007 13:36
		Re: T-nuts, their care and feeding By: Bob Brines on Sat, 27 January 2007 07:16
		Re: T-nuts, their care and feeding By: lon on Sat, 27 January 2007 10:53
		Re: T-nuts, their care and feeding By: gfederys on Fri, 02 February 2007 07:53
		Re: T-nuts, their care and feeding By: lon on Sat, 10 February 2007 16:05
		Re: T-nuts, their care and feeding By: Bob Brines on Sun, 11 February 2007 10:23
		Re: T-nuts, their care and feeding By: lon on Sun, 11 February 2007 11:41
		Re: T-nuts, their care and feeding By: Bob Brines on Mon, 12 February 2007 12:58
		Re: T-nuts, their care and feeding By: Jeffery L on Fri, 28 December 2007 07:08
		Re: T-nuts, their care and feeding By: badman on Thu, 03 June 2010 16:22
		Re: T-nuts, their care and feeding By: Wayne Parham on Thu, 03 June 2010 19:27
		Re: T-nuts, their care and feeding By: badman on Thu, 03 June 2010 23:11
		Re: T-nuts, their care and feeding By: badman on Fri, 04 June 2010 09:40
		Re: Just to muddy the waters.... By: Bill Epstein on Mon, 29 January 2007 03:32
		Re: Just to muddy the waters.... By: Bob Brines on Mon, 29 January 2007 10:39
		Re: Good point By: Bill Epstein on Mon, 29 January 2007 12:01

Previous Topic:	Need to find a cabinet refinisher
Next Topic:	Nostalgic DIYers

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 12 23:42:51 CDT 2024