AudioRoundTable.com: Craftsmen » So you want some expensive cone feet?

Home » Audio » Craftsmen » So you want some expensive cone feet?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

So you want some expensive cone feet? [message #29709]

Fri, 23 December 2005 02:49

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

I have stored in the junk drawer of my mind an article about using drill presss and sandpaper to make wheels for toys.

I needed an 1 1/2" round cylinder for a knob so I tried it. 80 grit on a sanding block barely made a dent in the Macassar Ebony I tried.

So I got out the belt sander! Vroom, vroom.

With the drill press spinning at 1900 RPM all I had to do was lay the sander on the table (it's sides are right on 90^ to the belt) and lightly hold the running belt against the spinning wood. In about 10 seconds I had a perfectly round cylinder.

After such a good result I tilted the drill press table to 45^ and proceeded to "turn" some cones from Ebony, Padauk and Cocobolo. No problem.

Who needs a lathe?

Report message to a moderator

[Message index]

		So you want some expensive cone feet? By: Bill Epstein on Fri, 23 December 2005 02:49
		Re: So you want some expensive cone feet? By: Shane on Wed, 28 December 2005 20:07

Previous Topic:	is there an equivalent PEM nut for wood?
Next Topic:	Conical horn project

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Aug 25 01:21:35 CDT 2024