AudioRoundTable.com: Craftsmen » Table saw recommendations?

Home » Audio » Craftsmen » Table saw recommendations?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: sucky Ryobi - Sorry, I disagree [message #29010 is a reply to message #29008]

Wed, 31 March 2004 18:01

wunhuanglo
Messages: 912
Registered: May 2009

Illuminati (2nd Degree)

The bearings were awful - the blade wobbled to a ridiculous degree; very rough cutting. And it was seriously underpowered, even with a thin-kerf blade.

AnD no, I don't think it was defective. I sent it to the factory and it came back as bad or worse.

Too much attention devoted to gimmicks, not enough to basics.

Report message to a moderator

[Message index]

		Table saw recommendations? By: crazychile on Mon, 29 March 2004 06:47
		Re: Table saw recommendations? By: Dean Kukral on Mon, 29 March 2004 07:34
		follow-up By: Dean Kukral on Mon, 29 March 2004 07:50
		Re: follow-up By: crazychile on Tue, 30 March 2004 06:19
		Re: follow-up By: Bill Fitzmaurice on Tue, 30 March 2004 06:56
		Re: follow-up By: Dean Kukral on Tue, 30 March 2004 18:50
		Re: follow-up By: Bill Fitzmaurice on Wed, 31 March 2004 06:11
		Re: follow-up By: Dean Kukral on Wed, 31 March 2004 06:33
		Re: follow-up By: Bill Fitzmaurice on Wed, 31 March 2004 08:38
		Re: More so with MDF By: BillEpstein on Wed, 31 March 2004 17:00
		Wait a minute By: Dean Kukral on Wed, 31 March 2004 06:49
		Re: Wait a minute By: Bill Martinelli on Fri, 02 April 2004 21:35
		Re: follow-up By: crazychile on Wed, 31 March 2004 09:40
		Re: follow-up By: Bill Fitzmaurice on Wed, 31 March 2004 09:56
		Re: follow-up By: crazychile on Fri, 02 April 2004 06:17
		Re: Table saw recommendations? By: Ryder on Mon, 29 March 2004 07:36
		Re: Table saw recommendations? By: elektratig on Mon, 29 March 2004 16:15
		Re: Table saw recommendations? By: wunhuanglo on Mon, 29 March 2004 16:45
		Re: All this is good stuff and.......... By: BillEpstein on Tue, 30 March 2004 20:32
		Re: BT3100 By: wunhuanglo on Wed, 31 March 2004 05:06
		Need more capacity? Make a bigger jig. By: Bill Fitzmaurice on Wed, 31 March 2004 06:06
		Re: REply to bigger capacity and sucky Ryobi By: BillEpstein on Wed, 31 March 2004 16:49
		Re: sucky Ryobi - Sorry, I disagree By: wunhuanglo on Wed, 31 March 2004 18:01
		Re: More space than saw By: Bill Martinelli on Wed, 31 March 2004 22:10

Previous Topic:	Tube PreAmp - Done! (almost)
Next Topic:	For Beginners

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 09 18:18:57 CDT 2024