AudioRoundTable.com: Craftsmen » Table saw recommendations?

Home » Audio » Craftsmen » Table saw recommendations?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: follow-up [message #28998 is a reply to message #28997]

Tue, 30 March 2004 18:50

Dean Kukral
Messages: 177
Registered: May 2009

Master

That's a good suggestion!

Norm Abrams (New Yankee Workshop) showed one of these some years back, and I made one. It made working with larger pieces much easier. Mine fell apart, and I have been too lazy to replace it. (But I should have!) You have to be sure to get the back side perpendicular to the tracks, or it will not cut square.

Report message to a moderator

[Message index]

		Table saw recommendations? By: crazychile on Mon, 29 March 2004 06:47
		Re: Table saw recommendations? By: Dean Kukral on Mon, 29 March 2004 07:34
		follow-up By: Dean Kukral on Mon, 29 March 2004 07:50
		Re: follow-up By: crazychile on Tue, 30 March 2004 06:19
		Re: follow-up By: Bill Fitzmaurice on Tue, 30 March 2004 06:56
		Re: follow-up By: Dean Kukral on Tue, 30 March 2004 18:50
		Re: follow-up By: Bill Fitzmaurice on Wed, 31 March 2004 06:11
		Re: follow-up By: Dean Kukral on Wed, 31 March 2004 06:33
		Re: follow-up By: Bill Fitzmaurice on Wed, 31 March 2004 08:38
		Re: More so with MDF By: BillEpstein on Wed, 31 March 2004 17:00
		Wait a minute By: Dean Kukral on Wed, 31 March 2004 06:49
		Re: Wait a minute By: Bill Martinelli on Fri, 02 April 2004 21:35
		Re: follow-up By: crazychile on Wed, 31 March 2004 09:40
		Re: follow-up By: Bill Fitzmaurice on Wed, 31 March 2004 09:56
		Re: follow-up By: crazychile on Fri, 02 April 2004 06:17
		Re: Table saw recommendations? By: Ryder on Mon, 29 March 2004 07:36
		Re: Table saw recommendations? By: elektratig on Mon, 29 March 2004 16:15
		Re: Table saw recommendations? By: wunhuanglo on Mon, 29 March 2004 16:45
		Re: All this is good stuff and.......... By: BillEpstein on Tue, 30 March 2004 20:32
		Re: BT3100 By: wunhuanglo on Wed, 31 March 2004 05:06
		Need more capacity? Make a bigger jig. By: Bill Fitzmaurice on Wed, 31 March 2004 06:06
		Re: REply to bigger capacity and sucky Ryobi By: BillEpstein on Wed, 31 March 2004 16:49
		Re: sucky Ryobi - Sorry, I disagree By: wunhuanglo on Wed, 31 March 2004 18:01
		Re: More space than saw By: Bill Martinelli on Wed, 31 March 2004 22:10

Previous Topic:	Tube PreAmp - Done! (almost)
Next Topic:	For Beginners

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 09 15:19:13 CDT 2024