Home » Audio » Pro Sound » Mashall AVT footswitch repair
Mashall AVT footswitch repair [message #27149] Thu, 06 October 2005 20:50 Go to previous message
arsbadmojo is currently offline  arsbadmojo
Messages: 1
Registered: May 2009
Esquire
Hello all, this post is just to make it easier if you need to repair your AVT footswitch. Mine went bad and the amp would get stuck on OD2.

If you are handy with a soldering iron, the part is easilly replaceable. I found an exact match from Mouser electronics - they are made by Alpha Switch Co. of Taiwan. Mouser part number 107-SF12011-M. This is just for the channel selector switches. The FX switches are the same part number, but end in L instead of M. They run about $6 each - a lot cheaper than a new switch.

Hope it helps someone out there!


 
Read Message
Read Message
Previous Topic: Guitar Amp Quesiton
Next Topic: Infrequent amp useage
Goto Forum:
  


Current Time: Sun Dec 01 12:50:39 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest