AudioRoundTable.com: Speaker » ribbon protection with electronic crossover?

Home » Audio » Speaker » ribbon protection with electronic crossover?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

ribbon protection with electronic crossover? [message #23602]

Mon, 02 April 2007 19:38

Steven Homrighausen is currently offline

Steven Homrighausen
Messages: 14
Registered: May 2009

Chancellor

If building an array using an electronic crossover and ribbon tweeters - a capacitor is needed between the amp and the tweeter line. How do I figure the value of that capacitor? Is there a general rule for the value? I don't want it to affect the crossover frequency set via the electronic crossover. I was thinking about two octaves below the crossover point - am I making this too simple? The steeper the crossover slope, the closer this cap can be?

Report message to a moderator

[Message index]

		ribbon protection with electronic crossover? By: Steven Homrighausen on Mon, 02 April 2007 19:38
		Re: ribbon protection with electronic crossover? By: Marlboro on Mon, 02 April 2007 21:08
		Re: ribbon protection with electronic crossover? By: Anonymous on Tue, 03 April 2007 09:16
		Re: ribbon protection with electronic crossover? By: Anonymous on Tue, 03 April 2007 09:16

Previous Topic:	Enclosure construction
Next Topic:	musical peaks / SPL / power distribution

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Nov 19 05:36:03 CST 2024