Home » Sponsored » Pi Speakers » 4Pi - alternate compression driver mounting?
Re: 4Pi - alternate compression driver mounting? [message #94486 is a reply to message #94485] Thu, 23 September 2021 02:03 Go to previous messageGo to previous message
areohbe is currently offline  areohbe
Messages: 20
Registered: May 2021
Chancellor
Here's my working design:

  • Shortened overall height by 1", depth & width not changed
  • Port is now 8.75"x2.4" w/ a depth of 3"
This result is a cabinet volume of 2.79 cubic feet, equivalent to the original design. I'm sure there are potential drawbacks with this approach but doubt my ear could pick it up. Getting excited to begin the build!

/forum/index.php?t=getfile&id=2854&private=0
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: room and amp questions
Next Topic: MDO - Instead of Plywood
Goto Forum:
  


Current Time: Wed Dec 11 20:16:15 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest