Home » Sponsored » Pi Speakers » 4Pi - alternate compression driver mounting?
Re: 4Pi - alternate compression driver mounting? [message #94485 is a reply to message #94481] Wed, 22 September 2021 22:53 Go to previous messageGo to previous message
areohbe is currently offline  areohbe
Messages: 20
Registered: May 2021
Chancellor
That looks lovely.

Turning the cabinet upside down makes sense. That's what I was planning on. Auto body filler is a great call!

I'd like to modify the port dimensions, also for aesthetic reasons. This is a bit over my head, but sounds like I'll need to consider standing wave issues. Think I will start with an MDF front baffle to take some acoustic measurements and go from there.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: room and amp questions
Next Topic: MDO - Instead of Plywood
Goto Forum:
  


Current Time: Thu May 30 08:45:46 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest