Home » Sponsored » Pi Speakers » 4 Pi Crossover
Re: 4 Pi Crossover [message #93059 is a reply to message #93058] Fri, 05 February 2021 08:55 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18691
Registered: January 2001
Illuminati (33rd Degree)

I'll send plans via email.

I would suggest swapping the midwoofer, then the tweeter compression driver and then the crossover board. Make sure you are focused on the right thing.

If it turns out it's the crossover, I'd replace the resistors first, followed by the capacitors. I can't imagine the coils going bad but if all else fails, I guess you could try swapping them too. But I'm sure you will have found your culprit long before you get to that point.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 4 Pi Impressions on Audiocircle
Next Topic: Pi 4 plans request and question regarding alterations
Goto Forum:
  


Current Time: Thu May 16 11:39:00 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest