Home » Sponsored » Pi Speakers » Low Pass
Re: Low Pass [message #91186 is a reply to message #91181] Sun, 17 November 2019 17:58 Go to previous messageGo to previous message
OutOfSpace is currently offline  OutOfSpace
Messages: 19
Registered: June 2017
Chancellor
One trick I read about and have used for guitar cables is to used balanced cable (microphone wire with two conductors + shield). The trick is to only connect the shield at one end, ideally the end with the best ground. This way, the any noise would get grounded and the signal would be cleaner. Not balanced cleaner, but better than carrying the signal on the shield, which is where the noise would be induced.
Chris
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 2 Pi Speaker Plans
Next Topic: Corner horns & flanking subs?
Goto Forum:
  


Current Time: Fri Apr 19 21:30:08 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest