Home » Sponsored » Pi Speakers » Build Thread: 2Pi Towers, 6Pi Corner horns (and possibly a sub and center) (Building some Pi Speakers)
Re: Build Thread: 2Pi Towers, 6Pi Corner horns (and possibly a sub and center) [message #88447 is a reply to message #88057] Sun, 15 July 2018 19:47 Go to previous messageGo to previous message
joshua43214 is currently offline  joshua43214
Messages: 35
Registered: October 2016
Location: USA
Baron
This forum has a 5 image limit, so here are some bonus pics for the tweeter.
index.php?t=getfile&id=2222&private=0

index.php?t=getfile&id=2223&private=0

index.php?t=getfile&id=2225&private=0


It is clear the mold was not up to temperature when the horns where cast, but A mold that size would take a while to warm up and add to the cost greatly.
It is a good idea to dress the area where the driver mounts, since it is anything but flat or smooth.
index.php?t=getfile&id=2226&private=0

Here is an image of the completed tweeter showing the rope caulk wrapping, and rubber glued to the bottom to prevent it from moving around.
index.php?t=getfile&id=2227&private=0
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 3pi crossover
Next Topic: 12pi hornsub questions
Goto Forum:
  


Current Time: Sun Apr 28 00:38:28 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest