Home » Audio » Speaker » Johnny5's four Pi build
Re: Johnny5's four Pi build [message #81505 is a reply to message #81424] Wed, 29 July 2015 17:26 Go to previous messageGo to previous message
johnnycamp5 is currently offline  johnnycamp5
Messages: 354
Registered: June 2015
Location: NJ
Grand Master
Hello all.

I'm wondering why I see so many 4pi builds with insulation installed on the bottom panel?

With the 4pi plans that Wayne sent me, under the "General construction tips", it states very clearly-

"Use R11 or R13 insulation, covering the interior top, side nearest the port and the rear".

It also says to hang a piece of insulation on the brace.

Therefore, there should be no insulation on-

1- the side opposite the port
2- The back side of the front baffle
3- The bottom.

Wayne sent me the plans about three weeks ago.
Have the 4pi's been revised?
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Digging out the old (?) ART array - some questions
Next Topic: Flanking subs
Goto Forum:
  


Current Time: Thu May 16 09:59:23 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest