Home » Sponsored » Pi Speakers » Jantzen 4pi crossover?
Jantzen 4pi crossover? [message #80787] Wed, 05 November 2014 03:38 Go to previous message
jmmbarco is currently offline  jmmbarco
Messages: 6
Registered: October 2014
Location: EspaƱa
Esquire
Hi everybody!

I am considering to use jantzen silver-Z caps and jantzen wax coils in the 4pi crossover (JBL 2226H and BC250) but I have some doubts.
For the 20uF, can I use the 22uF value or it is better to use two 10uF in parallel?
Is it possible to use wax coil? I was thinking about 12AWG.

About resistors, I intend to use Mundorf M-Resist HL 4x33Ohm in parallel. Should I put them offboard? or Would it be better to use the alluminium chasis type?

Thnak you very much in advance.

Best regards
JM
 
Read Message
Read Message
Previous Topic: 4Pi without subwoofer
Next Topic: 6pi plans
Goto Forum:
  


Current Time: Mon Jun 01 18:23:30 CDT 2020

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest