Home » Sponsored » Pi Speakers » 3 Pi 4 Pi horn cutout opening
Re: 3 Pi 4 Pi horn cutout opening [message #80375 is a reply to message #80372] Wed, 03 September 2014 15:10 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18683
Registered: January 2001
Illuminati (33rd Degree)

The older plans showed the cutout for the Eminence radial horn we used in the past. That has now been replaced with the H290C waveguide. The face is the same dimensions, and the routed lip is the same but the baffle cutout for the new waveguide is a little larger. People upgrading from the old to the new usually have to open up the cutout a little bit. There is also a small crossover change. See the thread below for more information:
 
Read Message
Read Message
Read Message
Previous Topic: Any Pi builders in Ireland ?
Next Topic: Start of build
Goto Forum:
  


Current Time: Tue May 07 22:43:22 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest