Home » Sponsored » Pi Speakers » 3 PI build (Building a pair of 3 Pi speakers)
Re: 3 PI build [message #79304 is a reply to message #78971] Wed, 05 February 2014 10:43 Go to previous messageGo to previous message
BFP is currently offline  BFP
Messages: 48
Registered: May 2009
Baron
I next ran the wiring from the crossover up through a hole in the base. I sealed the hole with electricians putty on the bottom and silicone on the top. I used batt insulation on the backs, bottom and side nearest the port. I also placed a batt on the window brace between the horn and woofer. I covered the batts in the woofer section with a layer of quilt batting to prevent any fibres from getting out of the box. I remember demoing some speakers one time and the salesman decided to show off and play a track of some thunder at an extreme level. A big chunk of fibreglass blew out the port. Needless to say I didn't buy anything from them and have always wondered if any fibres are being pushed from a fibreglass insulated box in routine operation.
Note! The camera somehow got switched to image stabilization mode which resulted in low quality pictures here.

Batts in place. I cut away some of the insulation for the horn/driver to fit.
index.php?t=getfile&id=1403&private=0

Quilt batting added.
index.php?t=getfile&id=1404&private=0

I also installed some "affordable" spikes. Carriage bolts, nuts and washers. In this case the size is 3/8". If you are doing something like this make sure you allow clearance for bolts to extend up into the enclosure. I set up the enclosures for a upward tilt of about 3/4" from back to front. This should get the sound up high enough to not need any stands.

index.php?t=getfile&id=1405&private=0

So now we are ready to add the drivers.


  • Attachment: DSCF9663.jpg
    (Size: 213.49KB, Downloaded 6411 times)
  • Attachment: DSCF9668.jpg
    (Size: 199.55KB, Downloaded 6434 times)
  • Attachment: DSCF9661.jpg
    (Size: 161.70KB, Downloaded 6413 times)
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Hi and a Few Questions
Next Topic: Happy Pi Day
Goto Forum:
  


Current Time: Wed May 15 17:31:05 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest