Home » Sponsored » Pi Speakers » Pi 3 or 4?
Re: Pi 3 or 4? [message #78604 is a reply to message #78603] Tue, 10 December 2013 12:17 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18680
Registered: January 2001
Illuminati (33rd Degree)

It is a pretty common question, you're right. And my answer is always that what you're really doing is choosing the midwoofer family more than anything else. Thes two speakers have very similar spectral balance. They are very much alike. This is even more true between the upgraded models. The four π speaker is slightly more efficient though.

Both the fully upgraded three π and the four π models generate deep, full bass, but it definitely rolls off in the lower midbass. I prefer the speakers when used with flanking subs, both for extension and for smoothing. Flanking subs mitigate the self-interference anomalies from reflections from the nearest boundaries, the wall behind the speakers being the most troublesome. Flanking subs also provide additional bass extension.

But that doesn't answer your question about differences. Measurements show little differences, really. There are some minor response differences, but overall, response is similar, that gentle rolloff down low. Midrange up, they're the same. The four π is more efficient though, about 3dB greater sensitivity than the three π speaker. And while distortion is very low in both speakers, the four π model is a little lower, especially at the lowest frequencies. Some would question how much that matters down low, and that's a valid question. But measurements show the four π speaker has slightly lower distortion at the lowest frequencies.

All in all, I think the biggest difference is probably the efficiency though. The speakers sound very much the same, both offer the same uniform directivity, the same pristine wavefront launch from the same waveguide/horn, both have a slightly overdamped alignment that is immune to parameter shifts and has gradual rolloff. So they're very similar in most aspects, with just a slight difference in efficiency between the two models.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 1pi or 2pi for surrounds?
Next Topic: 3pi 4pi?
Goto Forum:
  


Current Time: Sun Apr 28 16:07:07 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest