Home » Audio » Group Build » IR Remote Control
Re: IR Remote Control [message #73916 is a reply to message #73716] Mon, 24 September 2012 01:06 Go to previous messageGo to previous message
Wayne Parham is currently offline  Wayne Parham
Messages: 18675
Registered: January 2001
Illuminati (33rd Degree)

gofar99 wrote on Fri, 31 August 2012 21:25
Hi Wayne, my pleasure on the build. Smile A departure from tubes for a while and a learning experience. I noticed you used the two stage regulators. I believe that was important in the one I built as it made it quite stable and really quiet. The LM3916 is a good choice. They are inexpensive and work well with LEDs. I have one of the LM39XX series that has a built in led bar graph and wish I had more. They are scarce and last time I checked quite costly. I think the original cost was something like $4. Now about 10 times that.

I got LM3916 chips at DigiKey for about two bucks each.
I've put the IC sockets and relays on each of the four prototype boards. Going at a snails pace because I have so many more things on my plate. But it is a pretty simple circuit so I should have 'em done in the next few months, hopefully by the end of the year.

I'm using a little 5V relay that has excellent contacts and only takes 30mA holding current. So it's nothing for the regulators to drive:
The metal shop should have the front and rear panels done this week, so I'll post pictures when I get them.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Microphone Interface
Next Topic: RIAA preamp project
Goto Forum:
  


Current Time: Fri Apr 19 03:22:07 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest