Home » Audio » Thermionic Emissions » The Yokes on me
Coupling cap/grid choke, etc. [message #9550 is a reply to message #9548] Tue, 14 February 2006 06:51 Go to previous messageGo to previous message
Damir is currently offline  Damir
Messages: 1005
Registered: May 2009
Illuminati (2nd Degree)

My grid chokes are 1700H/8k amorphous "C"-core devices. The "Q" of the RCL circuit (choke model - inductor in series with resistor, and paralelled by winding capacitance) is Q=[(L/C)^0,5]/Rw. If we (simplified) observe L as a constant, and Rw=8k constant, too, then we can lower the Q (and avoid subsonic resonance) by enlarging the coupling cap, or by adding external resistance. Series external resistance Rout of the driver "dampens" the Q, and parallel R can also help a bit.
I simply used 4,7µF Mundorf Supreme coupling cap, "good compromise" between the cost/dimensions and value.

In the next couple of days I`ll post about this experiments on "Group Build" forum, but in short:
-E182CC cascode with ~20mA and Ra=15k has output impedance Rout=Ra`=Rin//Ra ~14kOhms. Amplification is A=gm*Ra`, and with gm~4ma/V and very large (infinity) loading impedance (grid choke, Zgch=2Pi*f*L) our amplification is A=4*14=56 times. We can say that we aproach this on high frequencies, say 10kHz, where Zgch=106,8MOhms theoretically and simplified. On larger frequencies, say 20kHz and up, Cw "comes into play" and with Rout of the driver forms low-pass filter. On the lowest frequency of interest, say 20Hz, our Zgch is "just" 213,6kOhms. In parallel with Ra`=14k, we have Ra``=14//213,6 = 13,139kOhms, and amplification is "only" 52,55 times. But, when we express this in dB, it`s a difference of only 0,55dB.
Is this negligible? In my listening tests these days I found that high Rout cascode in combination with grid choke isn`t really the best solution. Sound was bright, and bass was "anemic".
When I used the CCS parallel with Ra, and used Mu-out, then I got the "right" sound, from "bottom to top". Unfortunatelly, I don`t have measuring devices for objective evaluation of the circuit, just the subjective sound" results :-).
I didn`t notice bass boost / subsonic resonances, although Mu-out has low Rout (no ext. damping). As I said, good sound, bass "punch" returnes, and amplification is ~55.


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Another SET Forum You May Not Know About
Next Topic: New headphone amp.
Goto Forum:
  


Current Time: Thu May 16 19:10:33 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest