Home » Sponsored » Pi Speakers » Excited =)
Re: Excited =) [message #68518 is a reply to message #68496] Thu, 07 July 2011 22:48 Go to previous messageGo to previous message
Dave_S is currently offline  Dave_S
Messages: 28
Registered: April 2011
Chancellor
Bill,

I may start my build post this weekend, even though the speakers will not be fully complete. I have 8 clamps like the ones you are talking about. They are made by Jorgenson. You are right about the force needed. The glue bottle says one should have 100-225 psi of force. I reached 10 psi if lucky. I think the clamp force is closer to a vacuum press, which could never exceed 14.7 psi (atmospheric pressure). I would definately try the glue you recommended next time. Since you have clamps already, the press that I designed may be at least worth considering. I will probably add 4 more clamps for my next project. Trying some fancier veneers like you use would be interesting. I like zebrawood, but I have never found the right project for it. With the clamps, I might be able to experiment on small projects.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: PI4 Build for home theatre
Next Topic: Any Pi builders in Ireland ?
Goto Forum:
  


Current Time: Sun May 05 14:07:26 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest