AudioRoundTable.com: Pi Speakers » Rabbet dimensions for flush mounting (4Pi upgraded)

Home » Sponsored » Pi Speakers » Rabbet dimensions for flush mounting (4Pi upgraded) (Flush Mounting)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Rabbet dimensions for flush mounting (4Pi upgraded) [message #66970]

Sun, 10 April 2011 08:58

blvdre
Messages: 35
Registered: April 2010
Location: Burlington, VT

Baron

Hi All

I'm in the process of having a pair of cabinets built for my 4Pi speakers, and need to know what the correct dimensions would be for the rabbets required to flush mount the drivers. I know that the depth must accommodate a gasket, and the width must allow for a bit of play. I'm using the JBL 2226H and the H290 Horn. Any advice or suggestions are appreciated.

Report message to a moderator

[Message index]

		Rabbet dimensions for flush mounting (4Pi upgraded) By: blvdre on Sun, 10 April 2011 08:58
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: Wayne Parham on Sun, 10 April 2011 12:45
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: blvdre on Sun, 10 April 2011 19:34
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: Wayne Parham on Sun, 10 April 2011 23:17
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: blvdre on Mon, 11 April 2011 05:41

Previous Topic:	It's Here! T-2020 Chip Amp
Next Topic:	Three Pi & Four Pi Plans

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 22 21:24:21 CST 2024