Home » Sponsored » Pi Speakers » More Live Nude Resistors
More Live Nude Resistors [message #77882] Fri, 20 September 2013 15:44 Go to previous message
Bill Epstein is currently offline  Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA
Illuminati (2nd Degree)
Soon after upgrading the tone arm, some might recall, I removed the damping/shunt resistors from the DE-250s to get rid of what I thought was a dullness in the upper mid-range.

Since then I added the ZYX cartridge which, during break-in, made me:

switched suspension springs for the new HW-19 dampers

spent many hours dialing in the cartridge,

dis-assembled, tweaked, lubed spindled and mutilated the entire turntable,

measured, moved, re-measured and re-positioned the speakers on several occasions,

swapped amplifiers in, out and back again, and...

now realize that without those 15 Ohms the overall presentation was too bright. Back they went.

Still have the .33uF Cap, though ;-}

Hard to believe the R50 is the bottom of the ZYX line!
 
Read Message
Read Message
Read Message
Previous Topic: what is "jumper" L1 in the Pi 3 crossover?
Next Topic: Three PI X-over questions
Goto Forum:
  


Current Time: Sat May 11 12:35:47 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest