AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Plye drivers

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Plye drivers [message #34580]

Sat, 29 December 2001 09:13

hurdy_gurdyman
Messages: 416
Registered: May 2009

Illuminati (1st Degree)

I have a couple of old 12 inch Pyle MH1229 speakers lying around. The specs are:
voice coil= 1.5 in
sesitivity= 97 dB
fs= 59 Hz
Vas= 3.2 cu ft
Qts= .55
power= 95 watts
frequency responce= 65-6.5 kHz

Are these speakers worth using in a full range system with a compression horn and crossover? And what type of enclosure would work best?
Thanks in advance.
Dave

Report message to a moderator

Re: Plye drivers [message #34585 is a reply to message #34580]

Sat, 29 December 2001 11:27

Adam
Messages: 419
Registered: May 2009

Illuminati (1st Degree)

Naw, those are pretty crap drivers. Probably not worth the purchasing of quality compression drivers and crossover parts. The T/S specs are likely all wrong anyway.

Adam

Report message to a moderator

Re: Pyle drivers [message #34586 is a reply to message #34580]

Sat, 29 December 2001 11:33

Wayne Parham
Messages: 18784
Registered: January 2001

Illuminati (33rd Degree)

From the specs, that speaker works best in a two to eight cubic foot box, port tuned to 40Hz. PiAlign suggests 2 cubic feet, tuned to 40Hz with a 2.2" long, 2.5" diameter port. Deepest flat response is obtained with an 8 cubic foot box, tuned to the same frequency.

Report message to a moderator

Previous Topic:	More on the cheap 200 dollar PA speakers I want to build
Next Topic:	2 1/2 watt Tube Amp Runs Amok!!!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 18 22:09:13 CST 2024