AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » I want more bass!

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

I want more bass! [message #33916]

Wed, 26 September 2001 02:15

Frode
Messages: 49
Registered: May 2009

Baron

Hi Wayne!
I've tried your new compensation network in my 4Pi Pro. This made them sound even better(more "balanced"?). BUT, I would like to have more bass. I've tried to place the speakers in the corners. This gave me more bass, but I lost some of the other qualities I like. My room is to small for a 2242 sub, so I've thought of 3 possible solutions:

1. Build a 5 cu.ft box for my 2226.

2. Build 2 subs of ~2 cu.ft with drivers like the Peerless XLS

3. Build a single sub of ~5-6 cu.ft with a 15" driver
(haven't figured out which one yet)

Which solution do you think would be the best?

Report message to a moderator

Run TAD 1602's [message #33917 is a reply to message #33916]

Wed, 26 September 2001 04:20

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

You might look at the TAD 1602. It isn't terribly expensive like their compression drivers are, and you could use them for a subwoofer.

Ft 21Hz
Vas 519L (18.3 cu ft)
Qts 0.21
Qms 2.78
Qes 0.23
Re 6.2 ohms
Le 0.9mH
Xmax 5mm (0.2")
Pe 300W
Sensitivity 97.5dB
BL 21
Impedance 8 ohms

Running PiAlign on this driver, we enter Vad=18.2, Frd=21 and Qd=5. It suggests a cabinet size of 3.66 cubic feet with a port of 3 1/2" x 6 3/16" and 4 13/16" long.

Report message to a moderator

Re: Run TAD 1602's [message #33924 is a reply to message #33917]

Wed, 26 September 2001 14:28

pickle
Messages: 24
Registered: May 2009

Chancellor

That's intriguing, but the TAD's look expensive. MSRP is $635 each, on their website. I don't know anything about them. How do they sound in comparison to JBL? Anybody carry them online that you know of?

TAD TL-1602

Report message to a moderator

Re: Run TAD 1602's [message #33927 is a reply to message #33924]

Wed, 26 September 2001 17:00

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

MSRP is high, but "street cost" is more reasonable. You can get 1602's for $300 in good condition, about the same as JBL pro woofers.

Report message to a moderator

Re: Run TAD 1602's [message #33938 is a reply to message #33917]

Thu, 27 September 2001 05:16

Frode
Messages: 49
Registered: May 2009

Baron

Should I use the 2226's in a sealed box if I build a sub? Is two better than one?

TIA
Frode

Report message to a moderator

Re: Run TAD 1602's [message #33939 is a reply to message #33938]

Thu, 27 September 2001 05:34

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

I'd leave the four Pi design as it is, and just subwoofers. The rolloff is smooth and gradual, and blends very nicely with subs.

Report message to a moderator

Re: Run TAD 1602's [message #33940 is a reply to message #33939]

Thu, 27 September 2001 06:14

Frode
Messages: 49
Registered: May 2009

Baron

Is it best to use one or two subs?

TIA
Frode

Report message to a moderator

Subwoofers [message #33941 is a reply to message #33940]

Thu, 27 September 2001 06:36

Wayne Parham
Messages: 18791
Registered: January 2001

Illuminati (33rd Degree)

The more subs the better, because it tends to smooth room modes. That's more an issue than anything else.

Report message to a moderator

I like the old JBL 2235h woofers [message #33944 is a reply to message #33916]

Thu, 27 September 2001 07:45

Magnetar
Messages: 1
Registered: May 2009

Esquire

for subs. They are discontinued but can be found used for around $125.00 - $150.00 each. For the money you'd spend on the TADs you could run 4 or more of these. They really go low. Running a couple pair will rock the whole neighborhood!

Magnetar

Report message to a moderator