Home » Audio » Group Build » Removing volume pot
Removing volume pot [message #31234] Thu, 07 July 2005 08:25 Go to next message
colinhester is currently offline  colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas
Illuminati (3rd Degree)
Need to eliminate the volume pot from the SV811-10 amp. The schematic calls for a 100k pot. My question: Do I replace with a 100k ohm resistor from input/grid to ground, or is there a better value to use. I saw on another forum that someone suggested going with a 470k resistor when replacing a pot rated at 100k......Colin

Re: Removing volume pot [message #31235 is a reply to message #31234] Thu, 07 July 2005 10:12 Go to previous message
Brucie is currently offline  Brucie
Messages: 8
Registered: May 2009
Esquire
I replaced with 100K just as you outlined. No problems.

Previous Topic: Don't forget about BOI
Next Topic: Guinevere Power Trans
Goto Forum:
  


Current Time: Thu Mar 28 05:19:43 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest