Home » Audio » Group Build » Removing volume pot
Removing volume pot [message #31234] Thu, 07 July 2005 08:25 Go to next message
colinhester is currently offline  colinhester
Messages: 1349
Registered: May 2009
Location: NE Arkansas
Illuminati (3rd Degree)
Need to eliminate the volume pot from the SV811-10 amp. The schematic calls for a 100k pot. My question: Do I replace with a 100k ohm resistor from input/grid to ground, or is there a better value to use. I saw on another forum that someone suggested going with a 470k resistor when replacing a pot rated at 100k......Colin

Re: Removing volume pot [message #31235 is a reply to message #31234] Thu, 07 July 2005 10:12 Go to previous message
Brucie is currently offline  Brucie
Messages: 8
Registered: May 2009
Esquire
I replaced with 100K just as you outlined. No problems.

Previous Topic: Don't forget about BOI
Next Topic: Guinevere Power Trans
Goto Forum:
  


Current Time: Sat Nov 09 14:36:27 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest