The Lynn Sabin Jig: A Great Box Joint Jig [message #29404] |
Thu, 10 March 2005 08:06 ![Go to next message Go to next message](/forum/theme/AudioRoundTable/images/down.png) |
elektratig
Messages: 348 Registered: May 2009
|
Grand Master |
|
|
Fred T's inquiry at the Speaker Forum, in which he asks about small boxes for external crossovers, has roused me out of my torpor sufficiently to post concerning a great homemade box-joint jig. The link is below. If you have a tablesaw, this jig makes box joints easy. Highly recommended. I love using contrasting woods, light and dark: I made my mother-in-law a beautiful (if I do say so myself) box using maple and cherry, with cherry top and bottom, for Christmas, and a half-finished crossover box is waiting for me in the garage (when it unfreezes). I'm using a 30" version of the "basic" model, hardware from http://www.mcmaster.com (although you can get it almost anywhere). Slight wobbling can a be a problem, so the new "more stable" design is on my short list for this Spring.
|
|
|
Re: I like it! [message #29409 is a reply to message #29404] |
Fri, 11 March 2005 02:15 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) |
BillEpstein
Messages: 886 Registered: May 2009
|
Illuminati (2nd Degree) |
|
|
I've always just used the "tongue-same-sized-as-the-slot-cut-and-move-it-over-one" method but I love turning cranks, whirring gears and accurate stops. Thanks for the link. I have a box joint project in mind and will build this.
|
|
|