Home » Audio » Craftsmen » Need advice on etching, primer, and finish coat to aluminum chassis?
Need advice on etching, primer, and finish coat to aluminum chassis? [message #29258] Thu, 23 September 2004 08:42 Go to next message
Norris Wilson is currently offline  Norris Wilson
Messages: 361
Registered: May 2009
Grand Master
Hi everyone,

I would like to paint my Hammond aluminum chassis with a tough splatter type finish.

But since it has been several years, I thought that it would be a good idea if I requested some advice on products and method.

Since I will only be finishing a couple of boxes, I hope that what ever products that are suggested, will be available in an aerosol spray can?

Any method of finishing and product information will be greatly appreciated?

Thanks

Norris Wilson

Re: Need advice on etching, primer, and finish coat to aluminum chassis? [message #29259 is a reply to message #29258] Thu, 23 September 2004 17:36 Go to previous message
BillEpstein is currently offline  BillEpstein
Messages: 886
Registered: May 2009
Illuminati (2nd Degree)
See the post from Auntie-Polly on Tubes Forum here. The red looks even better in person. Rustoleum Professional. Limited colrs but great stuff. Clean the aluminum with Formula 401 or other grease cutter. Wipe off carefully. Primer. Paint.


Previous Topic: No table saw? No problem - build a sawboard
Next Topic: Welcome!
Goto Forum:
  


Current Time: Fri Mar 29 09:04:41 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Smith & Larson Audio
Smith & Larson Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest