Home » Audio » Measurement » Measuring Yorkville TX8 Cabs
Measuring Yorkville TX8 Cabs [message #25151] Sun, 28 March 2004 15:15
AJ is currently offline  AJ
Messages: 7
Registered: May 2009
Esquire
Hi, I want to find out where the factory design axis for the MF and HF horns is of the Yorkville TX8 cab.
Has any one taken 1m on axis measurents of these cabs using the
company's TX8P processor?
One would think the design axis would be between the horns,
but the reverse phase null measurements I'm getting here don't show a that point.When measuring at distance of 1M ,the reverse phase null is actually above the centre axis of the hf horn.Is this correct?
Cheers.



Previous Topic: Speaker Workshop question
Next Topic: The news from Raymond
Goto Forum:
  


Current Time: Fri Nov 01 21:00:54 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest