Home » Audio » Speaker » parameter values for Coral flat 10's
parameter values for Coral flat 10's [message #20280] Thu, 12 August 2004 11:12 Go to next message
jim denton is currently offline  jim denton
Messages: 162
Registered: May 2009
Master
Can someone guide me to a web location for the Theil values for a driver : Coral flat 10-----all I have is on the magent 8 Ohms--I want to start my research into a speaker design and have not gotten far on the spec's-----Jim

Re: parameter values for Coral flat 10's [message #20283 is a reply to message #20280] Fri, 13 August 2004 13:46 Go to previous messageGo to next message
Wayne Parham is currently offline  Wayne Parham
Messages: 18710
Registered: January 2001
Illuminati (33rd Degree)
Hi Jim,

I was planning to give you a few links I had, one to a large spreadsheet of T/S parameters for various drivers, another to Futtrup's Driver Parameter Calculator and a third to Speaker Workshop. But I looked and found that the first two of the three links aren't valid anymore. I don't know what happened to them. But if you want to download Speaker Workshop, there's a link in this post called "obtaining driver parameters." Also of interest is this link called "EMD Corals," which I found looking for the other references. It has a lot of good information on Coral speakers.

Wayne

Here you go :) [message #20310 is a reply to message #20280] Wed, 25 August 2004 04:00 Go to previous message
Kim Schultz is currently offline  Kim Schultz
Messages: 85
Registered: May 2009
Viscount

These are the TS parms measured from my own drivers.


Previous Topic: 25Hz monster horn
Next Topic: What makes a driver efficient?
Goto Forum:
  


Current Time: Sun Jun 23 08:57:24 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest